Black banner

Cat® 3406C Fire Pump Engine

Cat® 3406C Fire Pump Engine

The Cat® 3406C Industrial Diesel Fire Pump Engine is offered in ratings ranging from 218-359 kW (292-482 hp) @ 1750-2300 rpm. These ratings are non-certified and available for global non-regulated areas. They are FM Approved and UL Listed. Additional 3406C ratings with or without radiators are available, but not FM approved or UL listed. Starting on demand is a must for a fire pump engine – always. Cat® fire pump engines have a reputation for reliable starts and long efficient service.

Power Rating

Maximum Power

482HP

Rated Speed

1750-2300 rpm

Minimum Power

292HP

Emission Standards

Emissions

Non-Certified. Available for global non-regulated areas. FM Approved, UL Listed

General

Engine Configuration

Inline 6, 4-Stroke-Cycle Diesel

Bore

5.4in

Stroke

6.5in

Displacement

893in³

Compression Ratio

14.5:1

Aspiration

Turbocharged Aftercooled

Rotation from Flywheel End

Counterclockwise

Aftertreatment

-

Engine Dimensions - Approximate

Length

65.4in

Height

52.6in

Standard Equipment:

  • Air Inlet System
    • Dry or watercooled manifold and turbocharger
  • Charging System
    • Charging Alternator, 24 volt, 35 amp
  • Control System
    • Hydra-mechanical governor
  • Cooling System
    • Thermostats and housing
    • Jacket water pump, gear driven, centrifugal
    • Heat exchanger
    • Expansion tank
    • FM Required Raw Water Cooling Loops: 1.5" iron, horizontal or vertical, 1.5" 316 stainless steel, horizontal or vertical
    • Optional Radiator, not UL listed or FM approved
  • Exhaust System
    • Exhaust manifold, water-cooled (wet) or dry
    • Exhaust elbow, dry, 152 mm (6 in), 4 bolt flange
  • Flywheels And Flywheel Housing
    • SAE No. 1 flywheel
    • SAE No. 1 flywheel housing
    • SAE standard rotation
  • Fuel System
    • Fuel filter, LH
    • Fuel transfer pump
    • Primary fuel filter / water separator
  • Instrumentation
    • Instrument panel, LH
    • Engine oil pressure gauge
    • Fuel pressure gauge
    • Water temperature gauge
    • Service meter
  • Lube System
    • Crankcase breather
    • Oil cooler
    • Lube oil filter
    • Oil filler in valve cover and dipstick, both RH
    • Rear sump oil pan
    • Oil filler in valve cover
    • Dipstick
  • Mounting System
    • Supports
  • Power Take-offs
    • Flywheel stub shaft
  • Protection System
    • Stop-Start System, automatic (compatible with NFPA 20 requirements, able to be energized from either of two battery sources and capable of manual starter actuation)
  • General
    • Vibration damper and guard
    • Lifting eyes
    • Paint - fire pump red, optional radiator painted black

Optional Equipment:

Contact Us

Get A Quote

Thank you for your interest in Mustang Cat. We are here to help you in any way that we can. If you have a question, need equipment advice or just need additional information, we want to hear from you. You can email, phone or fill out the form below and we will be happy to connect with you.

    true I agree to all the terms and conditions

    This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.